Another lab session has ended and
again it was a new experience. For our
lab session, we were able to analyze the connection system of a breadboard and
how to solve for current, potential difference, and resistance when a series or
parallel connection is on a breadboard.
After the “exercises” given by Mr. Pacho, we continued with our
experiment. We were able to construct a
2-loop circuit in a breadboard. It was
really fascinating. I was the only one new to this breadboard in our group so I
really had an amazing time learning about how series or parallel circuits
should be constructed. In the end, we
were able to measure and record all the data needed and we also completed the
objectives of our experiment.
During
the experiment, we really had a tough time with our resistors. We replaced our resistors many times due to the
defects it had after several minutes exposed to a current. Maybe some of it was
not really of good quality so it burns easily or sometimes the metal rods
break. We also had a problem with our DC
voltmeter, so we changed it after an hour of experimenting with it.
I’m
sure that the next session would be dealing with hard concepts, but
nevertheless we will enjoy it. I’m
hoping for more amazing and fascinating lab sessions! GO FOR PHYSICS! ^_^
No comments:
Post a Comment